Large savings to be made with correctly aligned machines
Different types of machines
Rotating machines are usually described according to how they are connected to each other. Most common are horizontally mounted machines, usually a pump and motor. The machines can also be positioned vertically in some circumstances. Another type is offset mounted, or cardan-shaft-coupled machines. These often have some type of drive, for example rollers in a papermaking machine. Often several machines are connected in line, so-called machine trains, for example a gearbox between engine and the driven machine. A modern shaft alignment system can measure all the above types of machine. It also has important functions that aid the user in obtaining faster and better results:
- EasyTurn™: a program that makes it possible to take readings with as little as 40 degrees rotation of the shafts. Good when connections, motor guards etc prevent greater rotation.
- Thermal growth compensation: gives correct adjustment values even when the operating temperature differs between the machines.
- Tolerance check: graphic representation when the machine is within the tolerances.
- Documentation possibility
Correctly aligned shafts mean many improvements:
- Increased availability and productivity of the machine = assured production
- Increased service life of bearings and seals = fewer removals of replacement parts
- Complete seals = less leakage and better working environment
- Optimally utilised lubricant film = less risk of overheating and secondary damage
- Reduced lubricant leakage = less lubricant consumption
- Reduced friction = lower energy consumption
- Less vibration = reduced noise level
Greater overall savings with fewer spare parts, lower energy consumption and less unscheduled downtime.
HOW ACCURATELY DO YOU HAVE TO ALIGN?
Cardan-shaft coupled machines
The advantages of laser compared to traditional technology
Lasers are considerably easier and faster than dial gauges. Dial gauges often require experience and sometimes complicated calculations to be used. Because a laser measurement system can automatically compensate for thermal growth and indicate a good alignment, i.e. is within the tolerances for the relevant machine, no more time than is necessary is taken up for the alignment. Setting up a laser system for measurement on a machine takes a fraction of the time it takes for dial gauges and is much more reliable. For example, fixtures for dial gauges always drop a little, which affects the accuracy of the gauge’s displayed value. Play and clearance can also easily occur in mountings. Another factor that can affect the alignment result is the fact that gauges often have small scales and are difficult to read in poor light conditions.
Rulers and dial gauges are not a sufficiently accurate method for today’s modern machines. Using lasers always gives the same results regardless of who takes the measurements. The possibility of documenting the alignment results gives better control over the machines over time, and therefore greater assurance. The difference is also that in using a laser based alignment system the machines are actually checked. This is because checks are so easy and fast to carry out. The speed of use and the precision in alignment means that investing in a laser based shaft alignment system usually pays for itself within 3-6 months. Find out more under
Dual vs. single beam lasers
With dual lasers, the method used in Easy-Laser®, the accuracy depends on distance A. The greater the distance, the greater the accuracy. With the single beam system, the possible accuracy depends on distance B between the detectors. This distance is usually very short so the detectors have room inside the receiver unit (normally about 50 mm). In reality, with the measurement units installed on each side of a coupling, distance A is, in most cases, always longer than distance B.
[1: housing, 2: laser LED, 3: detector, 4: laser beam].